addition of quarry dust in concrete

addition of quarry dust in concrete

Effect of Quarry Dust on High Performance Concrete

3.4 Quarry Dust The quarry dust used for this investigation work is obtained from the quarry near tindivanam in Tamil Nadu. The quarry dust passing through 4.75 mm retained on 150 micron IS sieves are taken. Specific gravity of 2.617 and fineness modulus of 2.706 has been used. 3.5 Silica Fume The specific gravity of silica fume is 2.2.

High Performance Concrete using Quarry dust as Fine aggregate

ABSTRACT² This paper describes the experimental study of High-Performance concrete with quarry dust as fine aggregate in addition of steel fibre. To over-come the difficulties due to excessive sand mining, quarry dust was used as fine aggregate. Quarry dust is

Analysis of Concrete Made from Quarry Dust

concrete. Quarry dust is a byproduct that is generated from the crushing plants and which is abundantly available to an extent ... addition to fresh concrete would increase the water demand and consequently the cement content for given workability and strength requirements. Thus, the successful utilization of quarry

USE OF QUARRY DUST IN CONCRETE AS REPLACEMENT FOR

but quarry dust is useful for construction work as sand. If we mix quarry dust in sand then only 65% to 75% of sand replaced by quarry dust because strength of concrete is affected by this process. In other process if we mix quarry dust and fly ash are added together in concrete mix then we replace complete sand by quarry dust and fly ash. The ...

Partial Replacement of Sand by Quarry Dust in Concrete

investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25). The experimental results showed that the addition of quarry dust as fine aggregate ratio of 30%, 40% and 50% was found to enhance the compressive properties.

(PDF) Study on Performance of Quarry Dust as Fine ...

The suitability of quarry dust as alternative material for the river sand in concrete manufacturing is studied. M25 grade concrete was prepared with 0%, 20%, 40%, 60%, 80% partial replacement of ...

Characteristic studies on the mechanical properties of ...

was studied with various proportions of quarry dust (CM 1:3, CM 1:2, and CM 1:1). The experimental results showed that the addition of quarry dust for a fine to coarse aggregate ratio of 0.6 was found to enhance the compressive properties as well as elastic modulus. Key words: Concrete, quarry dust, fillers, elastic modulus, compressive strength.

(PDF) EFFECT OF QUARRY DUST AS PARTIAL REPLACEMENT OF

M2 (20% quarry dust), M3 ( 25% quarry dust ) , M4 (30% quarry dust) and M5 ( 35% quarry dust ) respectively. The above values shows concrete give adequate workability with the increase

Effects of crushed stone dust on some properties of concrete

Jul 01, 1996  The addition of dust to the concrete improves the impermeability of concrete because it blocks the passages connecting capillary pores and the water channels. This blockage is affected by the amount of dust content, and the more water passages were blocked, the more reduction in the permeability of concrete specimens is observed.

USE OF QUARRY DUST IN CONCRETE AS REPLACEMENT

but quarry dust is useful for construction work as sand. If we mix quarry dust in sand then only 65% to 75% of sand replaced by quarry dust because strength of concrete is affected by this process. In other process if we mix quarry dust and fly ash are added together in concrete mix then we replace complete sand by quarry dust and fly ash. The ...

[PDF] Utilization of Quarry Dust in Cement Concrete Paver ...

“A study of utilization aspect of quarry dust in Indian context” Natural river sand, if replaced by hundred percent Quarry Rock Dust from quarries, maysometimes give equal or better than the reference concrete made with Natural Sand, interms of compressive and flexural strength studies The strength of Quarry Rock Dust concrete is ...

Partial Replacement of Sand by Quarry Dust in Concrete

Quarry dust can be defined as residue, tailing or proportions of cement concrete + quarry dust (M 20, AND M25). other non-voluble waste material after the extraction and The experimental results showed that the addition of quarry dust processing of rocks to form fine particles less than 4.75mm. as fine aggregate ratio of 30%, 40% and 50% was ...

Partial Replacement of Sand by Quarry Dust in Concrete

investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25). The experimental results showed that the addition of quarry dust as fine aggregate ratio of 30%, 40% and 50% was found to enhance the compressive properties.

(PDF) Use of Quarry Dust to Replace Sand in Concrete – An ...

A. Mix proportioningTwo grades of concrete M20 and M25 having nominal mix proportion of 1:1.5:3 and 1:1:2 respectively were used by weight and w/c ratio was fixed according to the slump requirement of 60mm. For this concrete mix, quarry dust was added for replacement of

(PDF) EFFECT OF QUARRY DUST AS PARTIAL REPLACEMENT OF

M2 (20% quarry dust), M3 ( 25% quarry dust ) , M4 (30% quarry dust) and M5 ( 35% quarry dust ) respectively. The above values shows concrete give adequate workability with the increase

A review on the utilisation of quarry and ornamental stone ...

Jan 15, 2016  The addition of quarry dust and stone sludge to concrete affects mainly the properties of the cement paste close to aggregate grains. Due to particle packing phenomena, there is a porous and weak layer of cement paste, the so called interfacial transition zone, around the aggregates.

IMPACT OF QUARRY DUST DOLOMITE POWDER ON

ABSTRACT-The purpose of this work is to describe the effect of quarry dust and dolomite on the compressive strength of concrete. The present examinations indicate that dolomite may be used as partial replacement of cement in concrete and quarry dust may be suitably replaced with fine aggregate in concrete to some extent.

Effect of quarry rock dust on the flexural strength of ...

Jun 01, 2018  Portland limestone cement, river sand and quarry rock dust both of 2 mm maximum size as fine aggregate, and 14 mm crushed rock coarse aggregate were used for the concrete The particle size distribution and the physical properties of the fine and coarse aggregates are shown in Fig. 1 and Table 1 respectively. The fine and coarse aggregates satisfied the BS EN 12620:2002 + A1:2008

Implication of Metakaolin in Quarry Dust Concrete

initiation time of quarry dust concrete with various percentages of metakaolin have shown in Fig. 6 and Fig. 7. It is found from Fig. 6 that the time to initiate corrosion for quarry dust concrete was found to be 160 hours. Quarry dust concrete with 5%, 10%, 15% and 20% replacement of

Studies on Quarry Dust as Partial Replacement of Fine ...

1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

Experimental Study on Use of Quarry Dust and Fly Ash with ...

From the results of the experimental study, the following conclusions were drawn on concrete when quarry dust and fly ash are added in different proportions. 1) With the addition of 15% of fly ash and 15% of quarry dust the compressive strength increases to 22% then control mix M40 grade at 28 days.

Mechanical Properties of Fly Ash, RHA and Quarry Dust ...

Jun 08, 2015  Keywords: Quarry dust, Fly ash and Rice husk (QFR) concrete, Rice Husk Ash Concrete (RHAC), Quarry dust, Fly ash, Compressive strength Suggested Citation: Suggested Citation Arivalagan, S., Mechanical Properties of Fly Ash, RHA and Quarry Dust Addition in Conventional Concrete for Sustainable Construction: A Characteristic Study (June 8, 2015).

What is the unit weight of quarry dust? - Quora

In my practical experience, one cubic metre of quarry dust weighs 1,300 to 1,450 kgs depending on moisture content. To test your site, take a dry sample from the stockpile; methods may include an accurately measured tipper truck and wheel loader b...

Strength of cold bonded quarry dust aggregate concrete ...

increases the properties of concrete and increases the pull-out force. The mechanical properties of quarry dust addition in conventional concrete Sivakumaret.al. [5] investigated the hardened and durable properties of concrete using quarry dust. Raman et.al. [6] evaluated the suitability of quarry dust as a partial substitute for

The Utilization of Quarry Dust as Fine Aggregates in

1. To determine the significant properties of quarry dust and compare it with the properties of conventional sand. 2. To determine the best suitable ratio of Sand: Quarry Dust in concrete to obtain the desired design compressive strength. 2 Literature Review I. G. Balamurugan and Dr. P. Perumals carried out an experimental study on the

[PDF] Utilization of Quarry Dust in Cement Concrete Paver ...

“A study of utilization aspect of quarry dust in Indian context” Natural river sand, if replaced by hundred percent Quarry Rock Dust from quarries, maysometimes give equal or better than the reference concrete made with Natural Sand, interms of compressive and flexural strength studies The strength of Quarry Rock Dust concrete is ...

Mechanical Properties of Fly Ash, RHA and Quarry Dust ...

Jun 08, 2015  Keywords: Quarry dust, Fly ash and Rice husk (QFR) concrete, Rice Husk Ash Concrete (RHAC), Quarry dust, Fly ash, Compressive strength Suggested Citation: Suggested Citation Arivalagan, S., Mechanical Properties of Fly Ash, RHA and Quarry Dust Addition in Conventional Concrete for Sustainable Construction: A Characteristic Study (June 8, 2015).

(PDF) Use of Quarry Dust to Replace Sand in Concrete – An ...

A. Mix proportioningTwo grades of concrete M20 and M25 having nominal mix proportion of 1:1.5:3 and 1:1:2 respectively were used by weight and w/c ratio was fixed according to the slump requirement of 60mm. For this concrete mix, quarry dust was added for replacement of

IMPACT OF QUARRY DUST DOLOMITE POWDER ON

ABSTRACT-The purpose of this work is to describe the effect of quarry dust and dolomite on the compressive strength of concrete. The present examinations indicate that dolomite may be used as partial replacement of cement in concrete and quarry dust may be suitably replaced with fine aggregate in concrete to some extent.

Experimental Study on Use of Quarry Dust and Fly Ash with ...

From the results of the experimental study, the following conclusions were drawn on concrete when quarry dust and fly ash are added in different proportions. 1) With the addition of 15% of fly ash and 15% of quarry dust the compressive strength increases to 22% then control mix M40 grade at 28 days.

Studies on Quarry Dust as Partial Replacement of Fine ...

1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

Research Paper STRENGTH AND DURABILITY STUDIES ON

The test results show that the use of well graded quarry dust instead of sand along with admixture improves the strength of concrete. Further, the addition of inhibitors provides very good resistance against chemical attack and increases corrosion resistance. KEY WORDS: concrete, quarry dust, super plasticizer , corrosion resistance ...

Partial Replacement of Fine Aggregates with Quarry Dust ...

1.2 Properties of Quarry dust: Table 1.2 Properties of Quarry dust Organic material content Nil Compatibility with cement Use any type of Portland cement and blended cements for various mix designs Setting time Normal as preformed by river sand Workability Good Yield Rich mix Standard mix design for M20 grade concrete per Cum.

Research Article Study on Compressive Strength of Quarry ...

study the e ects of quarry dust addition in normal concrete and to assess the rate of compressive strength development. 2. Literature Review e suitability of quarry dust as a sand replacement material shows that the mechanical properties are improved and also

Utilization of Quarry Dust as Fine Aggregates in Concrete

Jul 22, 2017  The compressive strength of concrete was determined after replacing sand with quarry dust in various ratios. The results of the study showed encouraging results for replacement of 50% of sand with quarry dust. Keyphrases: compressive strength, fine aggregates, physical and engineering properties, quarry dust

Studies on quarry dust as partial replacement of fine ...

Quarry dust can be used as an economic alternative to the natural sand. In this investigation an attempt is made to utilize quarry dust as a partial substitute for natural sand in producing concrete. Natural sand is replaced by Quarry dust at an interval of 5%, 10%, 15%, 20% and 25%.

Experimental Study on Partial Replacement of Fine ...

of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, and M25). The experimental results showed that the addition of quarry dust as fine aggregate ratio of 30%, 40% and 50% was found to